AudioEngine A5+ User Manual

2. Keep these instructions for future reference.
3. Heed all warnings on the product and in this guide.
4. Follow all instructions.
5. Do not use this apparatus near water or moisture.
6. Clean only with a dry cloth and as directed by the manufacturer.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. Do not install near any heat sources, such as radiators, heat registers, stoves or other apparatus that produce
heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wider blade or
third prong are provided for your safety.
10. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. Use only attachments or accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time to prevent damage to this
product.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been
dropped
Unpacking
Your speakers were carefully tested and inspected before packaging and shipping. After unpacking please check for
any damage. It is rare that any damage occurs during shipping, but if this does happen contact the shipping company
immediately. We also recommend that you keep the original carton and packing material.
Quick Setup – Wireless connection
1. Connect the speaker wire from the left (powered) speaker to the right (passive) speaker.
2. Connect the power cable to the A5+ rear panel and plug the other end into an AC power outlet.
3. Connect the antenna to the A5+ rear panel.
4. Turn on the power switch on the rear panel. The A5+ will go into wireless pair mode and the Pair button on the
rear panel of the powered speaker should be flashing.
5. On your device, turn on Bluetooth and go to Bluetooth preferences. Select “Audioengine 5+” to pair and
connect. The Pair indicator on the A5+ rear panel should stop flashing and turn solid.
6. Play your music and adjust volume levels on A5+ and your device.
7. Repeat steps 5 and 6 to add additional devices. A5+ can connect only one device at a time, but it will remember
up to six devices.
To disconnect from a paired device and put the speakers back into pair mode, either remove the speakers from your
device or press and hold the Pair button on the rear panel until the indicator begins flashing.
Wired connection

AudioEngine A5+ Specifications

General

Product color	White
Housing material	-
Recommended usage	Universal
Remotely operated	Yes
Suitable for outdoor use	No
Magnet type	Neodymium
Tweeter diameter	20 mm
Speaker placement	Tabletop/bookshelf
Audio output channels	2.0 channels
Woofer diameter (imperial)	5 \
Amplifier class	A/B
Impedance	- Ω
Frequency range	50 - 22000 Hz
RMS rated power	50 W
Signal-to-Noise Ratio (SNR)	95 dB
Peak Music Power Output (PMPO)	150 W
Total Harmonic Distortion (THD)	0.05 %
Cables included	AC, Audio (3.5mm)
Connectivity technology	Wired
AC input voltage	115 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	4 W

Weight and Dimensions

Depth	200 mm
Width	180 mm
Height	270 mm
Weight	11400 g