AUX DC Inverter Free Match 50HZ R32
194
6.3 Installation of duct
There are two installation methods of duct ,as follow.
6.4 Drainage pipe
The drainage pipes should have good insulation measures. The specific steps are as follows:
a) The drainage hoses should be tightly clambed with the inner water outlet and the drainage
pipe respectively, then fix with a hoop
,
as shown in Fig1
b) Wrap the heat insulation cotton on the drain insulation pipe and the hoop , as shown in Fig 2
c) Tighten the sponge with a bandage
,
as shown in Fig3