EasyManuals Logo
Home>Axon>Digital Camera>AX1023

Axon AX1023 User Manual

Axon AX1023
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Axon Body 3 Camera User Manual
Axon Enterprise, Inc. Page 31 of 44
If the battery depletes significantly during use, the camera display will show LOW BATTERY
and the camera emits 4 quick tones and 4 short vibrations. This message indicates that
approximately 20 percent of the battery capacity remains. The message is repeated after
every 5 percent decrease in battery capacity.
Always recharge a depleted battery as soon as reasonably possible.
Charging an Axon Body 3 Camera while Powered Off
Note: Your Axon Body 3 camera must have Operating System (OS) v1.7 or later to charge
the camera while powered off. Prior to Axon Body 3 camera Operating System (OS) 1.7, an
Axon Body 3 camera that was powered off would automatically power on when connected
to a USB-C cable to charge.
The Axon Body 3 camera can be charged by using a USB-C cable while the camera is off. This
allows users to charge the Axon Body 3 camera battery when an Axon Body 3 Dock is not
available. However, Axon recommends that you regularly place you Axon Body 3 camera in
an Axon Body 3 Dock to ensure that the camera has the correct time synchronization and
latest firmware updates.
If needed, you can request a USB A to USB C cable directly from Axon. Contact your Axon
Representative or Axon Support for assistance.
1. While your Axon Body 3 camera is powered off, connect the camera to a USB-C cable.
2. Connect the cable to a power adapter or, for a USB-C to USB-A cable, to a USB port.
The camera enters low-power mode and the current charge level is shown on the
camera display.
The Operation LED color also provides a visual indication of the charge level. The LED is
red when the charge level is less than or equal to 33%, yellow when the charge level is
34% to 97%, and green when the charge level is 98% or higher.
While charging with the camera powered off, you can:
Power on the camera by pressing the Power button until you feel a short vibration.
The camera starts and enters Ready (buffering) mode.
Shut down the camera by disconnecting the USB-C cable.

Other manuals for Axon AX1023

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axon AX1023 and is the answer not in the manual?

Axon AX1023 Specifications

General IconGeneral
BrandAxon
ModelAX1023
CategoryDigital Camera
LanguageEnglish

Related product manuals