Azbil RJ-1 Series User Manual

11
AB-7329
 Installation
 WARNING

Install this product in a place, such as a control cabinet, where only the administrator has access to it.
Otherwise there is a danger of electric shock.
 CAUTION

Use this product under the operating conditions (for temperature, humidity, power, vibration, shock,
mounting direction, atmosphere, etc.) listed in the specications.
Failure to do so may cause re or device failure.

Installation and wiring must be performed by qualied personnel in accordance with all applicable safety
standards.
Failure to do so may cause re or electric shock.

After installing this product, check that it is steady and does not move.
Otherwise it may fall or fail.
z Installation location
The panel should be installed in a place that satises the following:
• An indoor place where is not exposed to direct sunlight
• A place where water is not splashed on the product
Note: The product is not waterproof.
This product should be installed in a panel.
The following space should be secured around the product.
The hatched area is for maintenance.
• The horizontal dimension varies depending on the number of I/O modules connected.
50 110
130
80
(3)
Model
RJ-11_ _W_ _ _ _
DIN rail clamps (both sides)
Model: 83104567-001
50
Duct
Duct
Duct
35140
105
50
120
Figure 5. Installation on DIN rail (single unit) (mm)

Azbil RJ-1 Series Specifications

General

Brand	Azbil
Model	RJ-1 Series
Category	Control Unit
Language	English