EasyManuals Logo
Home>Azbil>Control Unit>RJ-1 Series

Azbil RJ-1 Series User Manual

Azbil RJ-1 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
AB-7329
CAUTION
Take anti-lightning surge measures based
on regional and building characteristics.
Lightning may cause re or critical damage
to this product if protective measures are
not taken.
Keep the products in package for storage.
Failure to do so may damage or stain the
products.
Use this product under the operating condi-
tions (for temperature, humidity, power,
vibration, shock, mounting direction, atmo-
sphere, etc.) listed in the specications.
Failure to do so may cause re or device
failure.
Take anti-noise measures if this product
is installed in a location near source of
electric noise.
Failure to do so may cause malfunction or
device failure.
Installation and wiring must be performed
by qualied personnel in accordance with
all applicable safety standards.
Failure to do so may cause re or electric
shock.
All wiring must comply with applicable
codes and ordinances.
Otherwise there is a danger of re.
After installing this product, check that it is
steady and does not move.
Otherwise it may fall or fail.
Do not use an uninterruptible power supply
(UPS) that outputs rectangular waves.
Doing so may cause the device to fail.
CAUTION
For wiring, strip the insulation from cables
as specied in this manual.
If the length of exposed wire is longer than
specied, it may cause electric shock or
short circuit between adjacent terminals.
If it is too short, it may not make proper
contact.
Firmly tighten the terminal screws with the
torque indicated in this specications.
Insu󰀩cient tightening of the terminal
screws may cause re or overheating.
Do not block the ventilation holes of this
product. Doing so may cause device
failure.
Do not allow wire clippings, metal shavings,
and other refuse to enter into the product.
Doing so may cause re or product
damage.
Do not disassemble this product.
Doing so might cause device failure.
Before cleaning the product or retorquing
the terminal screws, be sure to turn o󰀨 the
power to the product.
Failure to do so may cause electric shock,
device failure, or malfunction.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Azbil RJ-1 Series and is the answer not in the manual?

Azbil RJ-1 Series Specifications

General IconGeneral
BrandAzbil
ModelRJ-1 Series
CategoryControl Unit
LanguageEnglish

Related product manuals