• Drive smoothly & steadily at speed
between 40 and 50 km/h .
• Drive at constant speed; avoid sudden
accelerations & harsh braking as far as
possible. Plan your trips properly with
minimum start-stops.
• Change the gear judiciously according to
the speed requirements. Drive as far as
possible in highest gear.
• Travel as light as possible; do not
overload the vehicle above the specified
payload.
• Stop the engine quickly at the end of the
journey. Avoid excessive idling. For
intermediate stoppages, cut-off the engine
if you want to stop for more than two
minutes.
Fuel Saving Tips
How to Ride Your Bike
14
Vehicle Maintenance (Ensure Following)
How to Ride Your Bike
13
Stopping the Vehicle :
• Close the throttle completely.
• Shift the transmission into neutral.
• Bring the vehicle to complete stop.
• Turn the ignition switch off.
Parking :
• Shift the transmission into neutral and turn
the ignition switch OFF.
• Support the motorcycle on a firm level
surface with the center or side stand.
CAUTION: Do not park on a soft/steeply
inclined surface or the motorcycle may
fall over.
Braking :
• Close the throttle completely, leaving the
clutch engaged (except where shifting
gears) so that the engine braking will help
slow down the motorcycle.
• Shift down one gear at a time so that you
are in Neutral when you come to a
complete stop.
• When stopping, always apply both brakes
at the same time. De-clutch as necessary
to keep the engine from stalling.
• Never lock the brakes, or it will cause the
tyres to skid. When cornering, use brakes
judiciously & do not de-clutch. Reduce
your speed before you get into the corner.
Fo r e m er ge n cy b rak i ng , di s reg a rd
downshifting, and concentrate on applying
the brakes as hard as possible without
skidding.
Fuel Check fuel lines and connections for
leakage.
Spark plug Inspect and clean spark plug. Adjust
electrode gap.
Air filter Clean air filter element periodically.
Engine oil Check level. Use recommended oil for
top up or refill.
Brakes Ensure that the brakes are not dragging
/ binding.
Clutch Ensure correct clutch lever play.
Tyre pressure Always maintain the recommended tyre
pressure.
Carburettor Adjust idling speed.