Video playback
Please note…
We recommend that you read the section,
‘Preferences for the video tape recorder’ on pages
52-54, as it gives relevant information about the
functions performed by the video tape recorder.
Use the Beo4 remote control to
operate your BeoVision Avant video
tape recorder.
While you are playing a tape, you can
turn the volume up or down as you
like; or mute the speakers.
You can select which tracks to play on
the video tape by stepping from track
to track.
Whatever operation you are
performing, pressing the STOP button
twice always stops the video tape
recorder, pressing the GO button starts
or resumes playback.
Press to start playing the tape you
have loaded
The picture appears on the screen
within a few seconds
Press to raise the volume
Press to lower the volume
Plays the next track on the tape
Plays the current track again – press
twice to play the previous track
Press to find a specific time on the
tape directly, e.g. 2:45, and then
play
Pauses the tape with a still picture
on the screen
Press again to stop playback
Press any time to start/resume
playing the tape
V TAPE
2
4
5
STOP
STOP
or
or
then
GO
Recordings and picture formats…
Video tape recordings will usually be played
back in the 15:9 format. If ”noise” appears
around the picture, you may have to change
the picture format to e.g. the 14:9 format
which lets the BeoVision Avant curtains hide
this ”noise”. See page 56-57 for more
information on formats.
To Next Page
Loading...
Need help?
General
