– 16 –
• Step 1: Get in front of the HANDBIKE BATEC ELECTRIC, with the handlebar cen-
tred in front of the wheelchair, with the brake on. (ee g. 14a, 14b)
• Step 2: Grab the HANDBIKE BATEC ELECTRIC by the handlebar and pull it to-
(ee g. 15)
• Step 3: Tip the handlebar, lifting the front wheel, while pulling the HANDBIKE
wheel back on the ground. (ee g. 16a, 16b)
•
•
ground. Your HANDBIKE BATEC ELECTRIC is now attached. (ee g. 17)
•(ee g. 18)
•
(ee g. 19)
• Step 3: Tilt the handlebar, lifting the front wheel, while you push the HANDBIKE
(ee g. 20)
•
bar, let go of the handlebar and set the front wheel down again. Your HANDBIKE
BATEC ELECTRIC is now detached. (ee g. 21)
ADVICE!
•
BATEC ELECTRIC HANDBIKE in Figure 58.
To Next Page
Loading...
Need help?
General
