Beckhoff AX5118 User Manual

BECKHOFF Drive Technology 4 Product description
AX5000 Version 6.2 25
4.7 Overview of connectors/terminal points
4.7.1 X01 - wide voltage input
Terminal point
Connection
Tightening
torque
3-phase
1-phase
L1
Phase L1
Phase L1
0,5 -0,6 Nm
L2
Phase L2
not used
L3/ N
Phase L3
Neutral conductor
PE
Protective conductor
4.7.2 X02 - DC link (AX5101 - AX5125 und AX520x)
Terminal point
Connection
Tightening
torque
DC+
DC link +
external brake resistor
and drive system
0,5 -0,6 Nm
DC –
DC link –
4.7.3 X02 - DC link (Only AX5140)
Terminal point
Connection
Tightening
torque
DC+
DC link +
only for drive system 1,2 -1,5 Nm
DC –
DC link –
WARNING
Serious risk of injury through high electrical voltage!
875 V DC voltage at the DC link terminals. Dangerous voltage may be
present for 5 minutes after the device is switched off. Measure the voltage
at the DC link contacts DC+ and DC-. The device is safe once the voltage
has fallen below 50 V.
Remove the connector only if you want to build a drive system with a AX-
Bridge. Remove the white hexagon plugs only if you wire the terminal
points again.
4.7.4 X03 - 24 V
DC
supply
Terminal
point
Connection
Current
consumption
Tightening
torque
U
p
+
Periphery supply
24 V
DC ±10 (depending on the
motor holding brake)
Depending on the
connected consumers
(see X06 and X14,X24)
0,5 – 0,6 Nm
U
s
+
System supply
24 V
DC ±25%
-12 A = 0.4 A – 0.8 A
18 A – 25 A = 1,1 A
40 A = 1,6 A
GND
GND

Beckhoff AX5118 Specifications

General

Brand	Beckhoff
Model	AX5118
Category	Servo Drives
Language	English