Decomissioning
CX9000 / CX901042 Version: 2.6
6 Decomissioning
6.1 Removal and disposal
A CX90x0 hardware configuration is dismantled in 2 stages:
0. Switching off and disconnecting the power supply
Before a CX-System can be dismantled, the system should be switched off, and the power supply should be
disconnected.
1. Removing from the top-hat rail:
Before the individual CX-System modules are disconnected, the whole CX-hardware block should be
removed from the top-hat rail. Proceed as follows:
1.1. Release and remove the first Terminal next to the power supply unit on the top-hat rail.
First remove any wiring from power supply unit and then from the first terminal on the top-hat rail next to the
power supply unit. If the wiring is to be reused for another system, it is advisable to make a note of the
connections. Then pull the orange terminal release (see arrow) to release the terminal and pull it out.
1.2. Releasing the CX-System
In order to release the CX-block, pull the white straps at the bottom of the module in the direction of the
arrows. They will lock in the extended position. After pulling the terminal release of the power supply unit, the
block can be removed carefully from the top-hat rail.
To Next Page
Loading...
Need help?
General
