12
3. INSTALLATION
The VIRTUALIZER was carefully packed in the factory and the packaging was designed to protect the unit from
rough handling. Nevertheless, we recommend that you carefully examine the packaging and its contents for
any signs of physical damage, which may have occurred in transit.
+ If the unit is damaged, please do not return it to us, but notify your dealer and the shipping
company immediately, otherwise claims for damage or replacement may not be granted.
Shipping claims must be made by the consignee.
3.1 Rack mounting
The Behringer VIRTUALIZER fits into one standard 19" rack unit of space (1 3/4"). Please allow at least an
additional 4" depth for the connectors on the back panel.
+ Be sure that there is enough air space around the unit for cooling and please do not place the
VIRTUALIZER on high temperature devices such as power amplifiers etc. to avoid overheating.
3.2 Mains voltage
Before you connect your VIRTUALIZER to the mains, please make sure that your local voltage matches
the voltage required by the unit! The fuse holder on the female mains connector has 3 triangular markers,
with two of these triangles opposing each other. Your VIRTUALIZER is set to the operating voltage printed next
to these markers, and can be set to another voltage by turning the fuse holder by 180°. CAUTION: this
instruction does not apply to export models exclusively designed, e.g. for 115 V operation!
3.3 Audio connections
All audio inputs/outputs on the Behringer VIRTUALIZER are unbalanced. Always use shielded cables of rela-
tively short lengths to avoid interference problems.
+ Please ensure that only qualified persons install and operate the VIRTUALIZER. During installation
and operation the user must have sufficient electrical contact to earth. Electrostatic charges
might affect the operation of the VIRTUALIZER!
All connectors are of the 6.3-mm mono phone jack type. If you use stereo plugs, please connect sleeve and
ring.
Tip = Signal
Sleeve = GND / Shielding
TipSleeve
Strain Relief Clamp
Unbalanced Operation with 1/4" Connector
Fig. 3.1 Mono phone plug
3. INSTALLATION
To Next Page
Loading...
Need help?
General
