Sidestand
The sidestand is located on the left side of
the frame. Raise the sidestand or lower it with
your foot while holding the vehicle upright.
TIP
The built-in sidestand switch is part of the
ignition circuit cut-o system, which cuts the
ignition in certain situations.
(See the following section for an explanation
of the ignition circuit cut-o system.)
WARNING
The vehicle must not be ridden with the
sidestand down, or if the sidestand cannot
be properly moved up (or does not stay
up), otherwise the sidestand could contact
the ground and distract the operator, re-
sulting in a possible loss of control.
Benelli’s ignition circuit cut-o system has
been designed to assist the operator in
fullling the responsibilityof raising the
sidestand before starting o. Therefore,
check this system regularly and have a Be-
nelli dealer repair it if it does not function
properly.
Ignition circuit cut-o system
The ignition circuit cut-o system (comprising
the sidestand switch, clutch switch and neu-
tral switch) has the following functions.
• It prevents starting when the transmis-
sion is in gear and the sidestand is up,
but the clutch lever is not pulled.
• It prevents starting when the transmis-
sion is in gear and the clutch lever is pul-
led, but the sidestand is still down.
• It cuts the running engine when the
transmission is in gear and the sidestand
is moved down.
Periodically check the operation of the igni-
tion circuit cut-o system according to the
following procedure.
To Next Page
Loading...
Need help?
General
