Bernal Sensor-Line S 401 User Manual

S 401 GB - 21 - 03-06
g Instructions radio sys-
tem PICO, 868,5 MHz
7.0 Operatin
Application: remote control for garage door
and gate openers
Technical data:
- Frequency 868,5 MHz
- Coding: KEELOQ
®
-Rolling Code System;
pre-programmed by the factory
- each receiver has a max. capacity of 28
transmitters, which can be programmed
- Power supply: standard 3 V CR2032 lithium
coin cell
- Range approx. 50 m, depending on the sur-
roundings
replacement: Battery
Loosen the battery cap on the rear side of the
casing by turning it to the left side (see draw-
ing) with your finger. Insert the new battery
with its positive pole forward into the battery
cap. Turn the battery cap together with the bat-
tery back into the casing.
IMPORTANT: Do not throw used batteries into
domestic waste; dispose them through battery
recycling system!
Transmitter types:
2- and 4-channel
Conformity:
The radio system conforms to the standards
EN300220-3 V1.1.1; EN301489-3 V1.4.1;
EN60335-1; EN50371 and may be put in circu-
lation without additional registration in the
countries of the EU and in Switzerland.
HomeLink
®
-compatible:
The HomeLink
®
-System integrated in some car
types can also be programmed with this
transmitter provided that the software-version
of the HomeLink
®
-System is version 8 or
higher.
Function:
Hybrid receiver 4-pole
(S 401)
pluggable MOLEX-
receiver (10-pole)
Programming:
1. push the learn
button on the PCB
until the display
shows a „L“ flash-
ing
2. push the transmit-
ter button, „L“ lights
up short-time and
then starts flashing
again
3. push the transmit-
ter button again,
„L“ lights up for
about 3 s, then it
disappears
4. the programming
mode is finished
automatically, the
radio system is
ready for use
Programming:
1. push the learn
button on the re-
ceiver short-time,
the green LED
lights up
2. push the
transmitter button,
the green LED ex-
tinguishes
3. push the
transmitter button
again, the green
LED flashes for
about 5 s and then
extinguishes
4. the radio sys-
tem is ready for use
Erasure:
Keep the learn button
pushed down for
about 5 s, „L“ lights
up and then extin-
guishes, all transmit-
ters are erased
Erasure:
Keep the learn button
on the receiver
pushed down for
about 10 s, until the
green LED extin-
guishes, all transmit-
ters are erased
Transmitting
direction
T1
T2
T3
T4

Bernal Sensor-Line S 401 Specifications

General

Brand	Bernal
Model	Sensor-Line S 401
Category	Garage Door Opener
Language	English