max
min
MAX.
MIN.
11109
NOTE: Drawings for illustration purpose only. May not
reflect actual product. Not to scale.
1. Insert the plug.
2. Press the “RESET” button, the indicator light turns on.
3. Press the “TEST” button, the indicator light turns off.
4. Press the “RESET” button, the indicator light turns on.
5. Press the “On/Off” button for 2 seconds, your pump is ready to use.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the
power outlet is suitable for the pump.
WARNING: Using an extension lead or multi plug adaptor with the spa heater can cause
the plug to overheat, causing damage to the equipment and surrounding items. The spa is
a class I electrical appliance and must be connected directly to a grounded socket. It is
recommended to only use a socket which is resistant to humidity and capable of high
power loading. Regularly check the plug and socket for signs of damage before using the
spa – do not use the spa if the plug or socket is damaged. If you are unsure about the
quality of the electrical supply, please consult a qualified electrician before use.
WARNING: The PRCD plug must be tested before each use to avoid risk of electric shock.
WARNING: Do not use the pump if this test fails. For assistance, please visit the support
section on our website, www.bestwaycorp.com.
PRCD Test
RESET
TEST
2
RESET
TEST
4
RESET
TEST
1
3
RESET
TEST
7 8
24
To Next Page
Loading...
Need help?
General