When inflating, you will notice that air will be expelled
from the area where the air hose connects to the pump,
this is normal for technique requirements.
Important: Don't cover the holes on the base of the
inflation hose. This operation will over inflate the liner and
damage the structure.
Do not use an air compressor to inflate the pool.
Do not drag the pool on rough ground as this may cause damage to the pool liner.
Inflation time for reference only.
SPA PUMP EQUIPOTENTIAL BONDING TERMINAL
It is recommended to arrange for a qualified electrician to connect
the spa pump to an equipotential bonding terminal using a
minimum 2.5mm
2
solid copper conductor.
Air Valve Check (for spa with quick inflation/deflation valve)
Always check the air valve carefully before inflation to ensure there is not an air leak.
If the air valve is loose, use the provided wrench to fasten the air valve following
these steps:
With one hand, hold the backside of the air valve from the inner side of the spa wall
and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
25
To Next Page
Loading...
Need help?
General