USA
page 32
USER SECTION
9. TROUBLESHOOTING
Type of problem Possible causes Cure
The machine does not
turn on
Main switch not ON. Turn switch ON.
The machine does not
load water.
Water valve shut. Open the hot and/or cold water valve.
7KH VSUD\ DUP QR]]OHV RU WKH
VROHQRLG ¿OWHU DUH FORJJHG DQGRU
caked with lime deposists
&OHDQWKHULQVLQJDUPQR]]OHVWKHSLSHVDQGWKH¿OWHU&KHFN
WKDWWKHZDWHUKDUGQHVVLVI(TXLSWKHPDFKLQHZLWK
an external water softener
Faulty pressure switch
5HSODFHWKHSUHVVXUHVZLWFKFDOOWKH7HFKQLFDO$VVLVWDQFH
service)
Washi ng results ar e
unsatisfactory.
7KHZDVKLQJQR]]OHVDUHREVWUXFWHG
or the rack does not rotate.
8QVFUHZ DQG FOHDQ WKH QR]]OHV DQG WKH URWDWLRQ VKDIW
FDUHIXOO\UH¿WWKHPFRUUHFWO\LQWKHLUVHDWV
Filters are dirty. 5HPRYH¿OWHUVFOHDQZLWKEUXVKXQGHUDMHWRIZDWHUDQG
replace in original position.
3UHVHQFHRIIRDP Use a non-foaming detergent or reduce the amount of that
used. Check the rinse aid dispenser
Fats or starches are not removed Detergent concentration too low
&KHFN WKH WDQN WHPSHUDWXUH LW
PXVWEHDERXW)&
$GMXVW WKH WKHUPRVWDW RU FKHFN FRUUHFW KHDWLQJ HOHPHQW
operation
/HQJWKRIZDVKLQJF\FOHLQDGHTXDWH
for type of grime build-up
Choose a longer cycle if possible, otherwise repeat wash
cycle
Wash water too dirty (PSW\ZDWHUIURPWKHWDQNFOHDQ¿OWHUVUH¿OOWKHWDQNDQG
FRUUHFWO\UH¿WWKH¿OWHUV
*ODVVHVRUGLVKHVDUHQRW
completely dried
,QVXႈFLHQWULQVHDLG ,QFUHDVHWKHDPRXQWRIULQVHDLGE\WXUQLQJWKHVFUHZRQ
WKHGLVSHQVHUVHHSDUDJUDSK
Rinse aid use)
The rack is unsuitable for the
glasses and dishes
Use a suitable rack enabling the dishes to be tilted so water
FDQUXQRႇ
The dishes have been too long in
the tank
$V VRRQ DV WKH ZDVK F\FOH LV ¿QLVKHG SXOO WKH UDFN RXW
immediately, allowing the air to dry the glasses and dishes
PRUHTXLFNO\
Rinse water temperature is less
WKDQ)&
Check the temperature of the booster thermostat. Call the
7HFKQLFDO$VVLVWDQFHVHUYLFHWRDGMXVW
6XUIDFHRIGLVKHVDQGJODVVHVWRR
rough or porous for material wear.
Replace type of dishes and glasses used
6WUHDNV DQG VSRWV RQ
glasses and dishes.
Too much rinse-aid chemical. Reduce the rinse aid amount by turning the micrometric
GLVSHQVHUVFUHZVHHSDU
Rinse aid use)
Too hard water. &KHFN WKH ZDWHU TXDOLW\ :DWHU PXVW QRW H[FHHG I LQ
KDUGQHVV(TXLSWKHPDFKLQHZLWKDQH[WHUQDOZDWHUVRIWHQHU
The machine suddenly
stops during the cycle
The machine is connected to an
overloaded circuit
&RQQHFW WKH PDFKLQH VHSDUDWHO\ FDOO WKH 7HFKQLFDO
$VVLVWDQFHVHUYLFH
$VDIHW\GHYLFHKDVEHHQDFWLYDWHG &KHFNVDIHW\GHYLFHVFDOOWKH7HFKQLFDO$VVLVWDQFHVHUYLFH
During wash cycle the
machine stops and draws
water
Water from the previous day has
not been replaced
(PSW\WKHWDQNDQGUH¿OOLW
Faulty pressure switch +DYHWKH7HFKQLFDO$VVLVWDQFHVHUYLFHFKHFNWKHWKHUPRVWDW
and the pressure switch
The overflow tube is incorrectly
positioned
5HPRYHWKHRYHUÀRZWXEHDQGFRUUHFWO\UHSRVLWLRQLW
Note For any other problems, contact the Technical Assistance service.
The manufacturer reserves the right to alter the technical characteristics without prior notice.