CD - Betrieb (Option)
59
DEUTSCH ENGLISH FRANÇAIS ITALIANO
NEDERLANDS
SVENSKA ESPAÑOL
PORTUGUÊS
Hi-fi calibration
You can set and store automatic calibrations for three different situations.
The calibrations are started and called up using the softkey (
).
You can select the following settings:
AUTO-EQ1 for the driver alone
AUTO-EQ2 for the driver and front-seat passenger
AUTO-EQ3 for passengers in the front and rear.
Press
EQ OFF to switch off the equalizer (EQ OFF in the display header).
To make the calibration hold the microphone in the corresponding position (do
not cover microphone opening).
For setting 1 (driver alone), position the microphone directly at the height of the
driver’s head. For setting 2, place the microphone between the driver and the
passenger on the front seat. For setting 3, place the microphone centrally be-
tween the front and rear seats.
Start Hi-fi calibration
During the calibration process it is important that the surroundings are very quiet.
Any outside noises will distort the readings.
The loudspeakers should not be blocked by any objects.
The car radio must be switched on.
• Place the microphone in the desired position.
The readings will be distorted if the microphone is placed in an incorrect position.
Depending on the vehicle and the position of the loudspeakers, the calibration
can be linear or can boost the bass sounds.
Try the settings to find out which one you prefer.
BA NewYork gb® 24.05.2002, 11:59 Uhr59
To Next Page
Loading...
Need help?
General
