59
EN
8. Checking the installation
Check the perimeter wire signal on the charging station LED indicator. When
the green light ashes once per second, the signal is OK. If the red light ashes,
this means there is a gap in the boundary wire and the signal cannot be sent.
9. Connecting the lawn mower to the charging station
Open the control panel cover by pressing the STOP button. Place the
lawnmower in the charging station and check the information on the LED
control panel. The mower will beep until the front panel cover is closed.
Note: If you have never used the mower or stored it unused for an extended
period of time, the battery must be charged before use. Charging one battery
takes approximately 2 hours for one battery and 4 hours for 2 batteries.
If the connection is good, the battery level will be displayed on the screen
during the entire charging process.
COMMISSIONING
Range of the mower
The automatic lawn mower is recommended for lawns with a size of 1200m².
The size of the area to be mown depends on the nature of the blades, the
type of grass, the growth rate, the humidity and the shape of the garden. The
run and loading time of the lawnmower may vary depending on the ambient
temperature. When the battery is fully charged and the outside temperature
is not more than 25 °C, a battery (depending on the age of the battery and the
thickness of the grass) can mowed for approx. 90 - 120 minutes.
To Next Page
Loading...
Need help?
General
