4.1 Brake Mounting
The new Roadmachine 01/02 proprietary front brake mounting hard-
ware comes with the ability to accommodate 140/160mm rotors.
Qualified service providers can position the adapter to create seamless
integration and optimal function for either rotor size.
Front brake
140 mm
160 mm
Rear brake
140 mm
160 mm
4.2 Cable Routing
4.2.1 Brakes
Start the housing routing at the
caliper and pass to the front
The rear brake hydraulic housing
will pass UNDER the bottom
bracket
Note: Roadmachine X will utilize Shimano flatmount
hardware front and rear – reference the Shimano service
guide for proper assembly
Install the provided foam sleeve on the
rear brake housing in the downtube
It is recommended to assemble the caliper-end hydraulic system (connector
insert, olive, and inserting the threaded connector bolt) – this will help hold the
hose in place during future assembly steps
4. Frameset assembly
ROADMACHINE - Integrated Cockpit System (ICS) Instruction Manual
To Next Page
Loading...
Need help?
General
