30
Remote control units
7
Starting point
You must begin by identifying
yourself by means of your code
number.
If the code number you entered
is correct, two acknowledge-
ment tones sound to indicate
that identification is completed.
Step Action Confirmation
1 Deactivate the anti-theft alarm
and switch on the ignition
2 Within 4 seconds, switch the
ignition off and immediately on
again THREE TIMES in succes-
sion
LED on,
1x acknowledgement
tone
3 Switch the ignition off within
15 seconds and then observe
the LED
LED flashes
4 Count the LED flashes until the
number corresponds to the first
digit of your code number.
5 Switch on the ignition while the
LED is on
LED off,
2x acknowledgement
tone
Repeat steps
3 to 5 for each successive digit
in your code number
Registering remote control units
DWA_5_2_eng.book Seite 30 Dienstag, 1. März 2005 4:59 16
To Next Page
Loading...
Need help?
General
