6
Alarm function
2
Activation with motion
sensor
The alarm function is activated
• by pressing button 1 on the
remote control unit once
or
• by switching off the ignition (if
programmed (
b 15))
– When you switch off the igni-
tion, 30 seconds elapse
before the activation phase
Activation is confirmed
• by the indicators flashing
twice
and
• by the alarm tone sounding
twice (if programmed (
b 15))
If you decide to activate the
alarm function more than
one minute after switching off
the ignition, you must press
button 1 for longer than one
second.
If it is left unprimed for longer
than approximately one hour,
the anti-theft alarm shuts itself
down in order to minimise the
power drain on the battery. If
you want to reactivate the alarm
function after this period of time
you must switch the ignition on
and then off again.
Activation
1 2
10DWAbkg3.book Seite 6 Mittwoch, 22. Februar 2006 12:53 12
To Next Page
Loading...
Need help?
General
