General instructions
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Information on additional mainte-
nance and repair work is provid-
ed in the Repair Manual for your
motorcycle on DVD/CD-ROM
(RepROM), which you can ob-
tain from your authorized BMW
Motorrad retailer.
Special tools and a thorough
knowledge of motorcycles are
required to carry out some of the
work described here. If you are
in doubt, consult a certified work-
shop, preferably your authorized
BMW Motorrad retailer.
Onboard-toolkit service
set
Your BMW Motorrad retailer of-
fers the onboard-toolkit service
set for additional work.
Information on conducting this
work is provided in the Repair
Manual on DVD/CD-ROM, which
is also available from your BMW
Motorrad retailer.
1 Pull-out tool holder
Holding of all tools with adapter
Removing and installing spark
plugs
2 1/4" bits
5x Torx, e.g. removing and in-
stalling rear wheel
2x Phillips
1x Straight-blade
3 3/8" Allen key, 22 mm
Removing and installing front
axle
8
86
z
Maintenance
To Next Page
Loading...
Need help?
General
