73n
Index Data Technology Repairs Car care Controls Overview
Onboard computer*
Mode selection
You can call up the onboard computer
data in the display from ignition switch
position 1 with the turn indicator lever.
Press the button briefly to select the
next display mode.
In addition, you can change the time by
pressing the key.
With the key, the calculations for
average fuel consumption and speed
are reset and begin again.
367us041
The illustration depicts the on-
board computer of the Z3 coupe
as an example. The onboard computer
of the Z3 roadster has minor differ-
ences in appearance.<
Time
The display is provided at ignition key
position 1 and above. In ignition key
position 0, the time is displayed for
approx. 8 seconds by pressing the
key.
Following a power loss, the clock auto-
matically switches to the setting mode:
The colon flashes. Two dashes are dis-
played for entering the hour.
367us040
Z3 cou
e
To enter the time
Enter the numbers for hours and min-
utes by pressing the key.
Enter the hour first. Each time the key is
pressed, the hour display increases by
one. Pressing and holding the key
starts the rapid advance.
Confirm the time set with the key.
Now enter the minutes when two zeros
appear.
Enter the minutes in the same manner
as the hours.
Press the save key : The time is
started exactly on the second. The two
dots stop flashing.
To reset the time
Press and hold the key for approx.
3 seconds: Enter the hour when the co-
lon begins to flash.
Enter the numbers by pressing the
key in the same manner as when enter-
ing the time.
To Next Page
Loading...
Need help?
General
