77n
Index Data Technology Repairs Car care Controls Overview
ASC+T/DSC* Parking lamps/Low beam
In the following exceptional circum-
stances, we recommend that you deac-
tivate the ASC+T/DSC system:
> When "rocking" the vehicle to free it
or when starting from a full stop in
deep snow or on loose surfaces
> or when driving with snow chains.
Refer also to page 105.
To reactivate the system
Press the button again; the indicator
lamp goes out.
Not even ASC+T/DSC can sus-
pend the normal laws of physics.
A driving style that is appropriate for the
conditions is always the responsibility
of the driver. For this reason, do not
take risks, using the additional safety
margin provided by the system as an
excuse.<
For additional details concerning
ASC+T/DSC, please refer to the chap-
ter titled "Advanced technology" on
page 177.
Parking lamps (position lamps/
side marker lamps)
Position 1
With the switch in this position,
vehicle lighting on both sides is on.
Low beam headlamps
Position 2
When you switch the ignition off
while the low beams are still on,
only the parking lamps (position lamps/
side marker lamps) remain on.
Instrument panel lighting
With the lamp switch in the "On" posi-
tion, turn the switch to adjust the illumi-
nation intensity.
367us021
"LIGHTS ON" warning
When you open the driver's door after
turning the ignition key to position 0,
a warning signal sounds for a few sec-
onds to remind you that the headlamps
have not been switched off.
Daytime running lamps*
The headlamps are automatically
switched on for daylight driving at igni-
tion key position 2.
To Next Page
Loading...
Need help?
General
