Speed warning
Principle
The speed warning can be used to set a speed
limit. A warning will be issued when this speed
limit is exceeded.
General information
The warning is repeated if the vehicle speed ex‐
ceeds the set speed limit again, after it has drop‐
ped below it by 3 mph/5 km/h.
Adjusting
1.
"CAR"
2. "Settings"
3. "General settings"
4. "Speed warning"
5. "Warning at:"
6. Turn the Controller until the desired speed is
displayed.
7. Press the Controller.
Activate/deactivate
1.
"CAR"
2. "Settings"
3. "General settings"
4. "Speed warning"
5. "Speed warning"
Accept current speed as the
speed warning
1.
"CAR"
2. "Settings"
3. "General settings"
4. "Speed warning"
5. "Select current speed"
Activating/deactivating
pop-ups
For some functions, pop-ups are displayed auto‐
matically on the Control Display. Some of these
pop-ups can be activated or deactivated.
1. "CAR"
2. "Settings"
3. "General settings"
4. "Pop-ups"
5. Select the desired setting.
Control Display
Brightness
1.
"CAR"
2. "Settings"
3. "Displays"
4. "Control display"
5. "Brightness at night"
6. Press the Controller.
7. Turn the Controller until the desired bright‐
ness is set.
8. Press the Controller.
Depending on the light conditions, the bright‐
ness settings may not be clearly visible.
Reset vehicle data
All individual settings can be reset to the factory
settings when the drive-ready state is switched
off.
1.
"CAR"
2. "Settings"
3. "General settings"
4. "Reset vehicle data"
5. "Reset vehicle data"
Seite 65
General settings
CONTROLS
65
Online Edition for Part no. 01405A37822 - VI/21
To Next Page
Loading...
Need help?
General
