93n
Index Data Technology Repairs Car care Controls Overview
Wind protection
Mounting
Attach the wind protector while the
convertible top is open and its cover
not mounted.
1 Push the brackets for the wind pro-
tector, with the zippers fastened and
facing to the front, onto both roll-over
protection bars as far as to the upper
edge of the chrome collars (arrow)
520de134
2 Guide the four fasteners to their
respective slots, attach them at an
angle, and press them into place
using the strap hanging in front of
them. Shove the four straps under
the inner side of the convertible top
3 Shove both the center elements all
the way to the vehicle's outside edge
(arrows), so that the cover can then
easily be mounted
4 Fit the cover if you wish to drive with
the convertible top open (refer to
page 40).
520de135
Removing
Loosen the mounting fasteners by pull-
ing on the four straps, then reverse the
sequence for attaching.
Put the folded up wind protector in its
protective sleeve and stow it in the lug-
gage compartment.
Online Edition for Part No. 01 41 0 155 083 - © 03/00 BMW AG
To Next Page
Loading...
Need help?
General
