28
What to do if ...
... the appliance doesn’t
work ...
... the appliance doesn’t
work and the safety pilot
light comes on ...
... the safety pilot light
comes on frequently ...
... the appliance fails to cool
the air properly ...
❏ Make sure that the appliance is plugged in properly.
❏ Make sure that the control knob is not set to "off" .
❏ Make sure that there is power in the mains
electricity supply and all the fuses are in working
o r d e r.
❏ Set the thermostat to a lower temperature when in
cooling mode or a higher one when in heating
m o d e .
❏ Make sure that there is nothing blocking the air
inlets or outlets on the appliance.
❏ The anti-overheating safety system may have
been activated.
Should the appliance not start working again
after a few minutes of its own accord, turn it off,
wait a few moments and then turn it back on
again.
❏ Place the appliance on a flat surface. If the pilot
light still doesn’t go out, then empty the appliance’s
internal water tank. (See instructions for
Temperature Control).
❏ Make sure that the drainage stopcock is set to the
right position.
❏ Make sure that the connections on hot-air expulsion
duct are in working order.
❏ Make sure that the expulsion duct is not
excessively bent or longer than 140 cm.
❏ Make sure that drainage stopcock is set to the
temperature control position.
Things that can save you from
making unnecessary phone calls
... the appliance does not
work in heating mode ...
To Next Page
Loading...
Need help?
General
