Robert Bosch GmbH 1 689 989 330 | 2016-11-30
Turning On and Off DCU 220 | DCU 220 | 7 | en
Chapter 2
Turning On and Off DCU 220
Turning On
Press the power button ( ).The Windows operating system should start.
Turning Off
When you finish a working session, you can stop the system by turning off the power or
leaving it in Sleep or Hibernation mode:
To.. Do this
Power off
(Shutdown)
Use the Windows Start menu in the lower left and
follow the shutdown procedure.
Sleep
Press the power button* or use the Windows Start
menu to put DCU 220 in Sleep mode.
Hibernate
Use the Windows Start menu to put DCU 220 in
Hibernation mode.
* “Sleep” is the default setting of the power button. You may change what the power button
does in Windows Control Panel.
To Next Page
Loading...
Need help?
General
