-19-
As you continue to take measurements, this cycle will
continue. The unit can display up to 3 previous mea-
surements.
The last three measurements will display on the mea-
sured-value lines c and the current measurement will
display on the result line d.
Area (Square Footage) Measurement
For area measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indica-
tor for area measurement and the word “Area” ap-
pears in the status bar. Select area measurement by
pressing the measure button 2 [ ]. Activate the laser
by pressing the measure button 2 [ ]. The laser will
be switched on.
2
L
⁄
4'02"
W
16'11"
0.0º
Aim and press the measure button
2 [ ] again to take the measurement
for length which will appear on the
top line of the measured-value lines c.
Aim and press the measure button
2 [
] again to take the measurement
for width which will appear on the
middle line of the measured-value
lines c and the area will automatically
be calculated and display on the result line d.
Volume (Cubic Feet) Measurement
For volume measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for volume measurement and the word “Volume”
appears in the status bar. Select volume measurement
by pressing the measure button 2 [ ]. Activate the la-
ser by pressing the measure button 2 [ ]. The laser
will be switched on.
To Next Page
Loading...
Need help?
General
