26
Changing the Unit of Measure
Select the “Measurement unit” in the tool settings.
Unit of measure “in” (inches) is set by default.
Set the required unit of measure and confirm by pressing
button 13 [Func].
To exit the menu item, press the On/Off/Clear button 9 [
] or
soft key 3 [ ]. The selected setting remains saved after you
switch off the measuring tool.
Changing the Angle Unit
Select the “Angle unit” in the tool settings.
Angle unit “°” (grade) is set by default.
Set the required angle unit and confirm by pressing button
13 [Func].
To exit the menu item, press the On/Off/Clear button 9 [
] or
soft key 3 [ ]. The selected setting remains saved after you
switch off the measuring tool.
TrackMyTools
Select “TrackMyTools” in the tool settings.
Confirm the setting by pressing button 13 [Func].
An initial activation is required. Data transmission is only
possible with the corresponding app or the corresponding PC
program.
After exchanging the batteries, the tool has to be switched on
shortly to re-activate TrackMyTools.
TrackMyTools can be disabled at any time.
Display Illumination
Select the display illumination in the basic settings (general
settings).
The display illumination is continuously switched on. When
no button is pressed, the display illumination is dimmed after
approx. 30 seconds to preserve the batteries.
The time until start of dimming is adjustable (tool settings).
The brightness of the display can be adjusted to the
surrounding conditions in multiple increments (general
settings).
To Next Page
Loading...
Need help?
General
