Bosch Indego S+ 500 User Manual

English | 31
Wire signal Detects the wire signal received from the perimeter wire, indicat-
ing its strength (for Service Agent).
The mower will not receive a wire signal while in the docking sta-
tion.
Troubleshooting
Online Support
http://www.bosch-diy.com/indego-help
Problem Possible Cause Corrective Measure
The LED on the dock-
ing station flashes
The perimeter wire is interrupted, too long
or too short. Wire not connected and
mower not in the docking station.
Check that the perimeter wire is not interrupted and is
between 20 and 350 meters in length. Then switch
power supply off and then on again.
Follow instructions in Installation Guide to install the
mower.
Excessive vibrations/
noise
Blade bolt loose Tighten blade bolt to torque of 2.5Nm.
Cutting blade damaged/bent
Replace cutting blade (see figure J).
Mower not docking
reliably
Perimeter wire not properly layed out
around docking station
Follow instructions in Installation Guide on layout of peri-
meter wire.
Perimeter wire close to a source of interfer-
ence
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Wrong docking station position setting Change setting in the "Advanced" menu.
Mower fails to operate Isolator switch not turned on Remove mower out of docking station, turn isolator
switch on and place mower back into docking station (en-
sure docking station is on – LED lights up green).
Possible clogging Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Battery not fully charged Place mower in the docking station to allow to charge.
Docking station must be on.
Grass too long Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower.
Battery too hot/cold The mower operates when the battery internal battery
temperature is between 5°C – 45°C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Bosch Power Tools F 016 L94 038 | (04.11.2020)

Bosch Indego S+ 500 Specifications

General

Power source	Battery
Battery voltage	18 V
Type	Robotic lawn mower
Cutting width	190 mm
Grass catcher	-
Product color	Black, Green
Cutting system	Rotary blades
Maximum lawn area	500 m²
Maximum cutting height	50 mm
Minimum cutting height	30 mm
Suitable for slope up to	27 %
Number of height positions	3
Cutting clearance adjustment	Yes

Weight and Dimensions

Depth	445 mm
Width	364 mm
Height	202 mm
Weight	7700 g