en
18
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault Possible cause Remedial action
Temperature differs
greatly from the set
value.
In some cases it is adequate to
switch off the appliance
for 5 minutes.
If the temperature is too high wait a
few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Displays do not
illuminate.
Power failure; the fuse
has been switched off;
the mains plug has not
been inserted
properly.
Connect mains plug. Check whether
the power is on, check the fuses.
Warning signal
sounds, alarm button
lights up. Fig. 2/5
The freezer
compartment is too
warm!
The frozen food is at
risk of thawing!
To switch off the warning signal,
press the alarm button 5.
Appliance is open. Close the appliance.
Ventilation openings
have been covered.
Ensure that there is adequate
ventilation.
Too much food was
placed in the freezer
compartment at once.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the alarm display goes out shortly
afterwards.
To Next Page
Loading...
Need help?
General
