English - 4
■ Before any work on the machine itself, pull
the mains plug.
■ For safe and proper working, always keep
the machine and the ventilation slots clean.
Remove any clogged sanding dust with a paint-
brush. From time to time remove the protective
cap 13 and clean the dust passage 14 so that the
suction performance remains at an optimum level
(see figure ).
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not
connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine, it must
be disposed of safely.
Measured values determined according to
EN 50 144.
PBS 60/60 E:
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 87 dB (A); sound
power level: 100 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
PBS 75 A/75 AE:
Typically the A-weighted sound pressure level of
the product is 84 dB (A).
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
Recycle raw materials instead of disposing as
waste
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
The plastic components are labelled for catego-
rized recycling.
Maintenance and Cleaning
C
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professional only
Noise/Vibration Information
Environmental Protection
11 • 2 609 932 116 • TMS • 28.02.03
To Next Page
Loading...
Need help?
General
