34/60 Installation
Bosch Rexroth AG, A10VO, A10VSO, A10VNO, A10VSNO Series 52 and 53, RE 92703-01-B/04.2018
7.4.8 Completing installation
1. Remove any installed transport screws.
CAUTION! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or damage
to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with
suitable, pressure-resistant, metal threaded plugs or connect the appropriate
lines.
2. Remove the transport protection.
The axial piston unit is delivered with protective covers(1) and protection
plugs(2). They are not pressure-resistant and have to be removed prior to
connection. Use a suitable tool for this to prevent damage to the sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
Bosch Rexroth service partner or the service department of the factory that
manufactured the axial piston unit.
1
2
1
3
4
Fig. 12: Removing transport protection
1 Protective covers
2 Protective plugs/threaded plugs
3 For versions with through drive,
protective cover and mounting bolts
4 For version with through drive, spacer
made of plastic (serves as transport
protection)
Ports intended for connecting lines come with protective plugs or threaded plugs,
which serve as transport protection. All ports required for the function must be
connected (see Table 11 “Ports A10VO, A10VSO, A10VNO, A10VSNO Series 52
and 53” on page39). Failure to do so could lead to malfunctions or damage.
If a port is not being used, plug it with a threaded plug since the protective plugs
are not pressure-resistant.
Adjusting the setting screws will render the warranty void. If you need to change
the settings, please contact your local contact person; you can find their contact
information under www.boschrexroth.com/adresses
To Next Page
Loading...
Need help?
General
