40/60 Installation
Bosch Rexroth AG, A10VO, A10VSO, A10VNO, A10VSNO Series 52 and 53, RE 92703-01-B/04.2018
To connect the axial piston unit to the hydraulic system:
1. Remove the protective plugs or threaded plugs from the ports where the
connections should be made according to the hydraulic circuit diagram.
2. Make sure the sealing surfaces of the hydraulic ports and functional surfaces are
not damaged.
3. Use only clean hydraulic lines or flush them before installation. (Observe
chapter7.5 “Performing flushing cycle” on page42 when you flush out the
entire system.)
4. Connect the lines in accordance with the installation drawing and the machine
or system circuit diagram. Check that all ports are connected or plugged with
threaded plugs. With inside-reservoir installation, the case of the axial piston unit
must be filled before fitting the lines and filling the reservoir with hydraulic fluid.
5. Tighten the fittings correctly (observe tightening torques!). Mark all properly
tightened fittings, e.g. with a permanent marker.
6. Check all pipes and hose lines and every combination of connecting pieces,
couplings or connecting points with hoses or pipes to ensure they are in safe
working condition.
Procedure
To Next Page
Loading...
Need help?
General
