11 Commissioning
General Information
Production failure due to uncontrolled ma‐
chine movement, caused by operation with‐
out Compact Flash card or by removal of the
Compact Flash card during operation.
Do not remove the Compact Flash card as long as the control is in operation!
Commissioning steps
For commissioning the control, further parameterization or programming is
necessary.
Proceed as follows to commission the control:
1. Mounting the control
(For details, please refer to chapter 10 "Mounting, Dismounting and
Electrical Installation" on page 25)
2. Insert the Compact Flash card with approved firmware
3. Connect the power supply via the connectors from the connector set
● For details, please refer to chapter 10.7.3 "Voltage Supply for the
Control" on page 38 and the relevant project planning manuals
4. Switch on the control
Possible production failure due to mal‐
function of the control if the control has
been switched off during the update
process.
Ensure that, depending on the software variant, " HW init" is displayed
after the control has been switched on. Wait unit the procedure is com‐
pleted (approx. 20 seconds). Do not switch off the control. During this
time an update is running. This procedure has to be completed. After
this the commissioning can be continued.
5. If necessary, use a lithium battery for the optional SRAM memory, see
also chapter 5 "Spare Parts, Accessories, and Wear Parts" on page 13
and chapter 14.4 "Lithium Battery" on page 53
6. If necessary, make other settings (IP address, subnet mask, gateway
address, ...) at the display. For further information, please refer to the
description of the relevant system (MLC, IndraLogic, MTX, MLC, XLC).
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
Bosch Rexroth AG 47/65
Commissioning
To Next Page
Loading...
Need help?
General
