English - 23
Source selection
You can switch between sources by pressing the appropriate source button on the
remote control. Before you begin, program the remote to control your source
(see page 22).
Select a source connected to the system
If your source is connected to the console and does not use CEC, follow this
procedure to set the console to the appropriate mode and turn on the source.
1. Power on the system.
2. Press the button for the source you want to control.
The source button glows.
3. Press
.
The source powers on.
Select a source connected to your TV
If your source is connected to your TV, follow this procedure to select the
appropriate TV input.
1. Power on the system, your TV and the appropriate source.
2. Press
to select the correct input on your TV.
You may need to press
several times to select the TV input for
the source.
On some TVs,
displays a menu. Use the remote control to choose the
correct TV input and close this menu.
Universal source buttons and
console connectors
The source buttons on your remote control correspond with the connectors on the
back of the console. For example,
corresponds with the BD-DVD HDMI
connector.
Your source buttons work with any source that is connected to the corresponding
connector. If you have a secondary DVD or Blu-ray Disc
™
player and connect it to
the CBL-SAT connector, it can be programmed to work with
.
If you are using the optical, coaxial, or analog connectors, you must set the input
for the appropriate source. You can access these settings using the System menu
(see page 25).
Using the System
To Next Page
Loading...
Need help?
General
Weight and Dimensions
