Bose DesignMax DM6SE User Manual

4 • English DesignMax DM6SE • Installation Guide
PRO.BOSE.COM
Setup
Installation Options
Installation Options and Accessories
q Mounting bracket (included)
w MBPWR-50 pan-and-tilt bracket (optional)
q w
Preparing the Weather-resistant Input Cover
The weather-resistant input cover is designed for three dierent wiring scenarios (see above). To change the configuration of the input
cover to support your wiring scenario, cut along the perforation on the rubber conduit.
Note: Indoor-only applications do not require use of the input cover.
Single In
In and Out Wide Open
Note: If using the wide open rubber conduit configuration, it is the
installer's responsibility to seal against water ingress into the Euroblock
connector.
Note: If installing the loudspeaker with the rubber conduit facing
upward, it is the installer's responsibility to seal against water ingress
into the Euroblock connector.

Bose DesignMax DM6SE Specifications

General

Tweeter	Yes
Magnet type	Neodymium
Speaker type	2-way
Driver diameter	165 mm
Speaker position	Front
Tweeter diameter	32 mm
Number of drivers	1
Speaker enclosure	Closed
Speaker placement	Ceiling-mountable, Stand-mountable, Wall-mountable
Audio output channels	- channels
Tweeter diameter (imperial)	1.25 \
Impedance	8 Ω
Sensitivity	88 dB
Frequency range	59 - 20000 Hz
RMS rated power	100 W
Crossover frequency	1.7 Hz
Signal-to-Noise Ratio (SNR)	108 dB
Peak Music Power Output (PMPO)	400 W
Product color	Black
Housing material	Plastic, Steel
Recommended usage	Universal
Bluetooth	No
Connectivity technology	Wired
Package weight	14700 g
Quantity per pack	1 pc(s)
Harmonized System (HS) code	85182200

Weight and Dimensions

Depth	229 mm
Width	222 mm
Height	340 mm
Weight	6400 g