9
Installation
Figure 2
TA-2 orientation for wall
mounting
For mounting in an enclosure
• Use an OnQ 28-in enclosure (363475-11) with a 28-in enclosure extender (364450-01), or
an equivalent enclosure that meets or exceeds the ventilation specifications.
• The enclosure must be mounted vertically on a ¾-inch (min.) plywood board.
• Mount the enclosure to the board using the mounting holes described in the OnQ installa-
tion instructions. In the U.S., #10 x 1.5-in sheet metal or
3
/
1
6
-inch diameter wood screws (or
4 mm diameter metric screws) are recommended.
• Mount the TA-2 amplifier inside the enclosure using all four mounting holes. Use the same
hardware as recommended for mounting it directly on a plywood board. The mounting
screws must extend through the metal enclosure and into the plywood board.
• Allow 12 inches (min.) between the top of the TA-2 amplifier mounting bracket and the top
of the enclosure for proper ventilation.
• Be sure to use proper attachment techniques for your wall construction type.
• Under all operating conditions, internal ambient temperature of the enclosure should not
exceed 104ºF (40ºC).
• Check local regulations before installing or wiring the TA-2 theater amplifier. The building
code may require professional installation by a skilled technician or licensed contractor.
Regional or electrical codes may require similar qualifications for wiring the system.
Allow 2 inches below unit for power plug and input/output connections
Allow 12 inches (min.) above unit for ventilation
9.275 in
14.40 in
11.0 in
3.50 in
6.25 in
To Next Page
Loading...
Need help?
General
