...
EXPANDING
YOUR AUDIO
LINK
The
Bose®
link
AR1
Wireless
Audio
Receiver
Your
AR1
receiver works with the
Bose®
link
ALB
Homewide
Wireless Audio Link transmitter. It provides wireless audio
reception for Bose link expansion room systems, amplifiers,
or
powered speakers.
You
can also use it with some older Bose products that are
not Bose link compatible or with a tuner/receiver or a pair
of
powered speakers that are not from Bose.
J
Note:
Use
of
the AR1 receiver with a
product
that
is
not Bose link
compatible requires
a special adapter cab/e. For further informa-
tion] refer to lilnstructions for non-Bose
or
older Bose products
lJ
on page
6.
Getting
it
ready
• Check the
AR1
receiver connection panel to make sure the
Setup Code switches are set
to
match those on the connec-
tion panel
of
the ALB transmitter. This ensures compatibility.
J
Note:
For further information on the Setup Code, refer to the
owner's guide that came with your
ALB
Homewide Wireless
Audio Link.
• Place the receiver within 7 feet
(2
meters)
of
the product it
connects to (using the supplied Bose link A cable).
• Place it within 80 feet
(24
meters)
of
the AL8 transmitter.
• Keep it upright with all feet flat on a level surface, such as a
floor, table, or shelf.
• Do not tip it on its side.
Connecting
to
a Bose®
link
compatible
product
These instructions are for use
of
the
AR1
receiver with a Bose
link compatible expansion product only. If they are not appro-
priate, refer to -"Instructions for non-Bose or older Bose prod-
ucts
J
'
on page
6.
1.
Connect one end
of
the supplied Bose link A cable into
the Bose link OUTPUT jack on the
AR1
receiver.
2.
Connect the other end
of
the cable to the Bose link Input
jack on the expansion room system, amplifier,
or
powered
speaker (Figure 1 on page
6).
5
To Next Page
Loading...
Need help?
General
