INSTRUCTIONS
User Manual 18
19 User Manual
Outdoor Remote Sensing
Outdoor remote sensing is enabled by installing a
Braeburn
®
remote outdoor sensor. No additional
configuration is required.
If a Braeburn outdoor remote sensor was installed you
may press the BACK and NEXT buttons at the same time
to view the outdoor temperature.
5
Thermostat Maintenance
Thermostat Cleaning
Never spray any liquid directly on the thermostat. Using a soft damp cloth wipe the outer body of the thermostat.
Never use any abrasive cleansers to clean your thermostat.
Changing the Batteries
This thermostat requires two (2) properly installed “AA”
alkaline batteries to provide power for the thermostat if
24 volt AC power is not connected. (See Installer Manual).
If batteries become low, a battery indicator will appear
in the display. You should change your batteries immediately
when you see the low battery signal by following
these instructions.
1. Remove thermostat body by gently pulling it from base.
2. Remove old batteries and replace with new batteries.
3. Make sure to correctly position the (+) and (-) symbols.
4. Gently push thermostat body back onto base.
NOTE: We recommend replacing the thermostat batteries annually or if the thermostat will be unattended for
an extended period of time.
+
+
To Next Page
Loading...
Need help?
General
