Page 17
Lift Installation Instructions
3
Power Cable and Ground Cable Installation
Red
Rubber
Boot
Power
Feed Stud
(under boot)
Power
Cable
Floor
Grommet
Ground Cable
Pump Module
CAUTION
Position and secure
ground cable clear
of lift operation.
L915 pump modules feature an external stud for
connection of the lift power cable and an external
ground cable. A 1" I.D. plastic grommet is provided
for the power cable and ground cable access hole.
Install grommet, ground cable and power cable as
outlined.
Floor Grommet:
Check under the vehicle to determine where the
optimum power cable access can be gained with
minimum obstructions. The recommended
grommet location is through the floor (pump side)
approximately two to three inches from the base
plate as shown.
Check for obstruc-
tions such as gas
lines, wires, exhaust,
etc. before drilling or
cutting. Failure to do
so may result in
serious bodily injury
and/or property
damage.
W
A
RNING
Use the 1-1/8"
diameter hole saw
to drill the grommet
access hole. Insert
the grommet in the
hole. Use two self-
tap screws to
secure the plastic
grommet.
Ground Cable:
Route the external ground cable through the
floor grommet. Secure the ground cable
below the floor with one of the base plate
mounting bolts. Place the ground cable
terminal on the mounting bolt sandwiched
between the star washer and the 3/8" flat
washer (except when 2-1/2" diameter body
washers are used). Position the terminal
between the 3/8" flat washer and the 2-1/2"
diameter washer when applicable. See
Figure L on page 15.
Route power cable
clear of exhaust
system, other hot
areas and moving
parts. Failure to do
so may result in
serious bodily injury
and/or property
damage.
W
A
RNING
Power Cable:
A red rubber boot is supplied in the installation package
to insulate the power cable connection. Slip the boot
onto the power cable end (with terminal). Remove the
3/8" hex nut and star washer from the external power
feed stud. Place the power cable terminal onto the
stud and secure with
the star washer and
nut. Tighten securely.
Position the rubber
boot over the cable
end.
Locate the vehicle
battery pack. Route
the 37' power cable
through the grommet to
the battery location
(details on pages 18
and 19).
CAUTION
Position and secure
ground cable clear
of lift operation.
To Next Page
Loading...
Need help?
General
