Briggs & Stratton Inverter Generator User Manual

Problem
Engineisrunning, but no AC
output is available.
Oaase
1. Red ovedoad alarm light is on. Generator
is overloaded.
Enginerunsgood at no°load but
"begs down" when leadsore
connected.
Enginewiii not start; shots
down when running or starts
and runsrough.
Enginelackspower.
Engine"hunts" or falters.
2, Greenoutput indicator light not on, Fault
in generator.
3, Poor connection or defective cord set.
4, Connecteddevice is bad,
1, Short circuit in a connected load,
2, Enginespeed is too slow,
3, Generator is overloaded,
4, Shorted generator circuit.
1, Engineswitch set to "Off".
2, Fuel capvent lever is in "Off" position.
1, Loadis too high.
2, Dirty air filter,
Carburetor is running too rich or too ban,
Correction
1. See Don't OverloadGeneratorin
Operationsection. Shut down
generator and restart.
2. Contact authorized service facility.
3, Check and repair.
4. Connect another devicethat is in good
condition.
1. Disconnect shorted electrical load.
2. Contact authorized service facility.
3. SeeDon't OverloadGeneratorin
Operationsection.
4. Contact authorized service facility.
1, Set engineswitch to "On".
2. Turn fuel cap vent leverto "On"
.
7.
to proper level or place
on level surface.
or replaceair cleaner,
fueltank.
Drain fuel tank and carburetor; fill with
fresh fuel,
Connectwire to spark plug,
8, Replacespark plug,
9. Drain fuel tank and carburetor; fill with
fresh fuel.
10. Wait 5 minutes and reocrankengine.
11. Contact authorized service facility.
12. Contact authorized service facility.
13. Contact authorized service facility.
1. See Don't OverloadGeneratorin
Operationsection.
2, Replaceair filter,
Contact authorized servicefacility,
19

Briggs & Stratton Inverter Generator Specifications

General

Brand	Briggs & Stratton
Model	Inverter Generator
Category	Portable Generator
Language	English