EasyManuals Logo
Home>BRIO>Water Dispenser>Signature Series

BRIO Signature Series User Manual

BRIO Signature Series
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
SAFETY PRECAUTIONS
Plug in the dispenser in the way described in this manual.
In accordance with these instructions, the dispenser must be properly located
and installed before use
Use only water. Do not use coee, tea or other beverages.
Dispenser must be unplugged before cleaning, sanitizing or repairing. Regular
cleaning is advised to ensure satisfactory water quality.
Always unplug the dispenser power cord before servicing or lter replacement.
Do not use with water that is microbiologically unsafe or of unknown quality.
periodically remove dirt and lint from the condenser on the back of the cooler.
Ensure the dispenser stands upright for 2 hours before loading water bottle, plugging
in or turning the unit on.
Always lift dispenser by handle located on rear of unit. DO NOT Lift dispenser by the
faucets, this part of the cooler may break and cause leaks if pulled by force.
Supervise children when using the dispenser; water from hot faucet will be extremely
hot and may scald.
The recommended placement of the water dispenser is indoors. Keep away from
direct sunlight and exessive moisture
WARNING: The hot water is heated to approximately 90°C (194°F). Temperatures
above 52°C (125°F) can cause severe burns from scalding. DO NOT ALLOW CHILDREN
TO USE THE HOT WATER DISPENSING BUTTON WITHOUT PROPER AND DIRECT
SUPERVISION.
IMPORTANT: To provide additional protection from the risk of shock, the dispenser
MUST be connected to a ground fault circuit interrupter (GFCI) outlet at all times. Use
of an extension cord will void any warranties. See warranty document for complete
terms and conditions.
WARNING: The dispenser must be grounded – if the appliance is improperly ground-
ed, it may result in an electric shock
Do not connect the dispenser to the power outlet yet. Install the dispenser on a at and secure
place approximately 4 inches (10cm) from the wall.
If you need to move the dispenser, wait approximately 1hour after turning o the power. Upon
moving, do not tilt the dispenser more than 45 degrees.
Make sure that the electric socket is correctly grounded to prevent electric shock.
Check If the Water Levers are rmly closed.
This dispenser is intended for indoor use only.
Do not expose to direct sunlight.
Cautions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BRIO Signature Series and is the answer not in the manual?

BRIO Signature Series Specifications

General IconGeneral
BrandBRIO
ModelSignature Series
CategoryWater Dispenser
LanguageEnglish

Related product manuals