Brother CS-8060 User Manual

Replacing the Presser Foot 37
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Removing the presser foot
holder
Remove the presser foot holder when cleaning the
sewing machine or when installing a presser foot that
does not use the presser foot holder, such as the
quilting foot. Use the screwdriver to remove the
presser foot holder.
■ Removing the presser foot holder
1
Remove the presser foot.
• For details, refer to “Replacing the presser
foot” (page 35).
2
Use the screwdriver to loosen the presser foot
holder screw.
1 Screwdriver
2 Presser foot holder
3 Presser foot holder screw
■ Attaching the presser foot holder
1
Align the presser foot holder with the lower-
left side of the presser bar.
2
Hold the presser foot holder in place with
your right hand, and then tighten the screw
using the screwdriver in your left hand.
1 Screwdriver
Note
● If the presser foot holder is not correctly
installed, the thread tension will be
incorrect.
1
3
2
S2_brotherE.book Page 37 Wednesday, May 14, 2003 8:05 PM

Brother CS-8060 Specifications

General

Brand	Brother
Model	CS-8060
Category	Sewing Machine
Language	English