www.brother.com
Brother
General
Sewing
Accessories
12
Straight Stitch Foot
Straight Stitch Foot and Straight Stitch Needle Plate
Vertical Stitching Alignment Foot
Stitch Guide Foot
The scale in the presser foot can be used for perfect topstitching on both
straight and curved lines. Each divisional mark equals 2 mm.
1. Select straight, zigzag, or decorative stitches.
2. Sew the stitches keeping a certain seam allowance.
To sew a curve, sew so that the fabric edge becomes a right angle against the presser
foot.
Straight Stitch Foot
For precise straight stitching on thin fabrics or on edges of fabrics. Use
this presser foot only with the center straight stitch.
Straight Stitch Foot and
Straight Stitch Needle Plate
Use the Straight Stitch Foot with the Straight Stitch Needle Plate to
accomplish perfect straight stitching. Helpful for straight stitching
especially on thin fabrics or small pieces of patchworks. Installing the
Straight Stitch Needle Plate automatically sets the needle position to the
center straight stitching position on selected machines. Use this presser
foot only with the center straight stitch.
Brother
General
Sewing
Accessories
11
Seam Guide
Side Cutter
Stitch Guide Foot
Seam Guide
Guides fabric edge with an accurate 1/4 inch, 1/2 inch, or 5/8 inch
(approx. 6.5, 13, or 16 mm) seam. It can be used with all Brother
presser feet. Can be used for stitching heavy fabrics together.
1. Attach the seam guide on the needle plate with the thumbscrew of the seam guide.
2. Adjust the distance and place the right edge of the fabric against the seam guide.
3. Sew.
Side Cutter
Creates the perfect cut edge like a serger or overlock. Selecting a stitch
designated for the Side Cutter allows you to create a beautiful finish without
any adjustment on stitch settings.
1. Make a cut about 2 cm (3/4’’) long in the seam line of the fabric.
2. Select a stitch, and adjust settings as needed.
3. Place the cut right section on the top of the foot guide plate.
4. Slip the left side under the presser foot.
5. Lower the presser foot and guide the fabric through the presser foot as it stitches.
SA538
AB
C:Innov-is900D/SE-350/HE-240/LB6770
SA177
ABCDEJ
SA178
L
SA108
GHILOP
SA167
ABCDEFJKMN
SA160
ABCDEFGHJKLMNO
SA550
A
SA189
ABCDEFGHJKLMNO
Vertical Stitching Alignment Foot
(Quattro
TM
6000D)
This specially marked "V" foot is included with the Quattro
TM
6000D but
is also sold as an accessory for other Innov-is models. The side
extension ruler on this foot lets you measure the distance from the
needle to the edge of your fabric consistently. Great visibility while you
add creativity to your next project!
Available in Fall 2008.
To Next Page
Loading...
Need help?
General
