12
Sfera Keypad Module
User and installation manual
STAND-ALONE
KEYPAD MODULE
DOOR LOCK
SHORT OPENING
CODE
MAX. OPENING CODE
Door lock connected
to the C/NO/NC local
relay of the keypad
module
SPEAKER MODULE +
KEYPAD MODULE
DOOR LOCK
SHORT OPENING
CODE
MAX. OPENING CODE
Door lock connected
to the S+ S- contact of
the speaker module
Door lock connected
to the C/NO/NC local
relay of the keypad
module*
* To use this function, make sure that the keypad module is configured with M=3 or M=23
Use of the device
The BTicino Sfera Keypad Module allows residents to open a door lock through the recognition of
previously stored numerical codes.
The device consists of a backlit pushbutton panel with 12 keys and LEDs to control the correct
entry of the code.
When combined with speaker module item 351100/351200/351300 and appropriately configured,
it also allows direct call.
Note: This manual refers to the Sfera wired stand-alone Keypad Module or paired with the Sfera Speaker
Module (351100/351200/351300).
If the Sfera Keypad Module is installed linked to the Display Module (352500) refer to the Display
manual for the code programming.
Caution: the secret code must consist of a minimum of 4 to a maximum of 9 digits.
Door lock control
he TiSferaDesign software can be used to set the maximum number of digits of the code (min. 4 to
max. 9).
Entering the codes to open the door lock varies depending on the code length (if it is shorter than
or the same as the maximum set) and the type of installation.
The correct form to use in the specific cases is shown in the tables below.
Door lock control with stand-alone Keypad Module 353000
Door lock control with Sfera Speaker Module 351100/351200/351300 and Keypad
Module 353000
The link between a Sfera Speaker Module and the Keypad Module allows the management of two
door locks. The table below shows how to use the codes correctly.
Note : the local relay closing time of the Keypad module is 4” and cannot be modified.
To Next Page
Loading...
Need help?
General
