Bticino Sfera Keypad Module User Manual

20
Sfera Keypad Module
User and installation manual
6
6. If the procedure is successful, the green LED stays on for approximately 1 second and then
starts flashing again.
Enter another code or end the procedure.
Press and quickly release the programming pushbutton, or wait 30 seconds to exit the
programming procedure.
A short beep and the switching off of the LED indicates that the programming sequence is
complete.
The Sfera Keypad module is ready for normal operation.
During the programming procedure, it will be necessary to follow some rules:
- keys must be pressed in succession (with maximum 2 seconds in between pressures).
- the programming sequence must start within 30 seconds from the pressure of the
programming button, and must be completed in one stage.

Bticino Sfera Keypad Module Specifications

General

Brand	Bticino
Model	Sfera Keypad Module
Category	Control Unit
Language	English