30
Sfera Keypad Module
User and installation manual
6
5
If the procedure is successful, the green LED stays on for approximately 1 second and then
switches off.
During the programming procedure, it will be necessary to follow some rules
Keys must be pressed in succession (with maximum 2 seconds in between pressures).
The programming sequence must start within 30 seconds from the pressure of the
programming button and must be completed in one stage.
6. Enter the code again to confirm. The device emits a long confirmation beep.
5. Press the
key
A short beep confirms the programming of the new resident code.
To Next Page
Loading...
Need help?
General
