EasyManuals Logo
Home>Bunn>Coffee Maker>CDBC

Bunn CDBC User Manual

Bunn CDBC
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Page 8
CEZ ADJUSTMENTS & OPTIONAL SETTINGS
+
+
+
++
LOCK UNLOCK
TEMPERATURE
205
CAL
J2
J5
J1
J6
J3
J7
COUNTER
TRM2
TRM1
READY
LED
BOM PART NO. 28742-
4 1
J6
205°
(200°)
(195°)
(190°)
(185°)
CAL
TEMPERATURE
205°
(200°)
(195°)
(190°)
(185°)
CAL
TEMPERATURE
IMPORTANT: The tank must be full and fill
solenoid shut off prior to making these ad-
justments.
Adjusting Brew Volumes
The brewer is factory set to deliver 64
ounces ± 2 for each brew cycle.
BREW VOLUME SET-UP: Use the following
steps when the setting is unknown or a differ-
ent circuit board is being installed.
1. Place an empty funnel in the funnel rails
and an empty decanter or graduated ves-
sel beneath the funnel.
2. Place the "ON/OFF" switch in the "ON",
upper position.
3. Press and hold the brew start button until
you hear the brew solenoid click on-and-
off three times (approximately 5 seconds).
Release the button.
4. Allow the cycle to continue until the de-
sired amount of water is dispensed and
then turn "OFF" the brewer.
The brewer is now set to dispense this amount
of water for each subsequent brew cycle.
To increase the amount of water for each
brew cycle place an empty funnel in the funnel
rails and an empty decanter or graduated
vessel beneath the funnel. Place the "ON/OFF"
switch in the "ON", upper position. Press and
hold the "BREW" switch until you hear the
solenoid click on-and-off three times (ap-
proximately 5 seconds), then release the
"BREW" switch. Momentarily press and re-
lease the "BREW" switch once for each ounce
(approximate) of water to be added to the
prior setting and allow the brew cycle to finish.
To decrease the amount of water for each
brew cycle place an empty funnel in the fun-
nel rails and an empty decanter or graduated
vessel beneath the funnel. Place the "ON/OFF"
switch in the "ON", upper position. Momen-
tarily press and release the "BREW" switch
once for each ounce (approximate) of water
to be removed from the existing setting. Press
and hold the "BREW" switch until you hear
the solenoid click on-and-off three times (ap-
proximately 5 seconds), then release the
"BREW" switch and allow the cycle to finish.
P1864
P1865
29079 041599

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bunn CDBC and is the answer not in the manual?

Bunn CDBC Specifications

General IconGeneral
BrandBunn
ModelCDBC
CategoryCoffee Maker
LanguageEnglish

Related product manuals